In this case connect the cable to the WAN Port. If you opted for the 4G LTE antenna, your antenna may have 2 ports. Connect the cover and reinstall the cover. To connect the cable to the antenna, remove the cover at the bottom to reveal the ethernet port. (note the included POE injector will not be used at this stage, so do not connect to the sign). And connect the other end directly into your antenna. Connect the Antenna cable to the signal 2 port on the main section. Your Antenna cable has a 9 pin connector on one end and an ethernet/RJ45 connector on the other end. The antenna connects to the signal 2 port on the outside edge of the sign below the sensor. How to connect your LED Sign’s network antenna. And follow proper safety procedures to prevent electrical shock. Note the color code for your wires:īe sure to secure the power connector to them before turning the power on. The main cabinet is usually on the left side of the sign (when looking at the front of the sign).Īfter plugging in your power cables, you will need to terminate the wires to your junction/breaker box (not included). Depending on your configuration, there will be a 9-pin connector or 4 pin connect in the power 2 port on the main cabinet. The power 2 port on the main cabinet has been converted to your brightness sensor port. Plug the power cable to Power 1 on the main cabinet, and Power 1 or Power 2 on the remaining sections. You will connect one power cable to each section. The second end of the cable is either unfinished or has terminal connectors preinstalled.Īll Sections, except for the main section, have two power ports, with the labels Power 1 and Power 2. Your power cables are the 13/14 AWG cables with a preinstalled 3 Pin Weatherproof connector on one end.
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |